Apply an oil-free lash cleanser, micellar water or our Awange Label Lash Mousse directly to your natural lashes to remove all traces of makeup, skincare, and oils from your eye area. Use downward motions with a clean lash or make up brush. Your natural lashes must be completely clean and dry before applying any product.

Start a timer. Beginning at the outer lash - apply 8 light dabs of bond at the base, from the under side of your natural lashes avoiding the waterline. Work in sections using only one dip of bond per section.

Apply a small amount of bond to the base of the cluster.

Once 40-60 seconds has passed, you're ready to apply the cluster.

Starting from the outer corner. Use the tweezers to apply one cluster at a time

Position the cluster 1mm away from your waterline to avoid irritation.

Place each segment one by one, moving toward the inner corner and slightly overlapping them as you move inward. Make sure to keep applying bond to each of the lash segment bases as you're applying them.

Apply sealant to the inside of your tweezers then apply the sealant directly to the bonded areas at the base - do not coat the entire lash length.

Gently clamp the lashes with the tweezers to ensure they’re locked in.

After applying the sealant, wait for 30-60 seconds to allow it to dry completely.

Avoid water, steam, or excessive humidity for 24 hours to maximize your lash wear time.

See our Lash Playbook below for more tips

Gently apply the lash removal serum to both the top and bottom of the lash base. Allow the remover to sit for 30-60 seconds to weaken the adhesive.

Use the tweezers to gently clamp the lash extension. They should easily slide off, if you are met with resistance DO NOT force them off, instead apply more remover and wait a bit longer before attempting again.

After removing lash extensions, use a makeup pad with micellar water to wipe away any residual buildup followed with the Lash Mousse Cleansing routine.